Payment & Shipping Terms:
|Product Name:||PVC Welding Machine||Power:||3400W|
|Usage:||Mesh Cloth/banner /knife Scraping Welding||Material:||PE、TPO ECB、CSPE、|
|Type:||Hot Air Welding||Packing Size:||560*410*420mm|
pvc seaming machine,
banner welding equipment
2-6cm Automatic Banner Welding Machine Portable PE / TPO ECB / CSPE Material
specification parameters :
|Machine Name||Seamless LaserPVC , Flex , plastic Banner Welding Machine|
|Other name||Automatic Leister Heat air gun Plastic Welding machine|
|Heat air gun||Import Original 3400W Leister Heat Air Gun from Swiss|
|Voltage||110V / 240 V|
|Temperature scope||20 - 700 degree|
|Welding area||2-5 cm|
|Welding thickness||0.22 - 2 mm|
|Welding Type||automatic welding|
|Frequency||50 - 60 HZ|
1. Any part of this machine being bumped of fallen can cause some damage impossible to be repaired.So please pay attention to carry it.It is suggested to move the machine by manpower and put it down carefully.
2. Please check if there is damage or missed parts after unpack the machine.Any problem, please contact us or the local agent immediately.
3. The place for installation must be flat and the floor is strong enough to support the machine and moreover, the installation place should close to power supply.
4. Keep the installation place no dust and avoiding sunshine.
5. Please sweep away the anti-rust oil from the machine with detergent and re-lubricate with light lubricating oil after installation.
1. Make the cloth for seaming flat and tight,. take joiner to accurate (about 2-4cm),Fix both ends by tape or glue on ground.
2. set the temperature and walking speed: Connect the power supply, set the temperature and walking speed according to the thickness of the cloth. Temperature and speed is adjustable. As shown:
3. Turning the heating switch (yellow knob), the machine starts to heat up. Wait for 2 minutes,when actual temperature (PV)approach desire temperature(SV),we can start weld.
4. Welding positioning. Lap welding pressure(working wheels)- wheel edge must be aligned with the upper edge of the banner
4.Lifting the handle, making the working wheel on ground,as the show
6. start welding: pulling the heat gun to position handle and making the nozzle close to ground then move the nozzle to left so that it can be place a right position, at that time, the welding will work automatic.
7. During welding,let hot air nozzle between two overlap pieces. And be make sure hot air nozzle and Rubber wheel walk in straight line.if not,please adjust by handrail.check photo:
8. finishing welding: when we finish these work, pull the handle shake, turn right to move out nozzle until stops rotating nozzle upwards and it is locks.
9. Turn off the switch: when finished, turn off the yellow knob,shut off main power supply when the PV value is less than 50 degree.then we can turn off the power.
Thank you very much for choosing our “Automatic TOP-3400 banner welding”. We believe that this will be your best choice for your business. This equipment is designed professionally for ,sealing film or foil and homogeneous coating and PE-coated webbing belt lap welding that is make in PVC-P,PE,TPO ECB,CSPE,EPDM,PVDF. To help you understand the characters features of this equipment and know how to operate safely and keep in good condition etc.