Original Printer Spare Parts Inkjet Printer Nozzle For Hot Foaming Printer

lecai origianl 750 Silver printhead for hot foaming printer

description :

locor nozzle is a new nozzle, life time expertise, 100% on the machine, 100% does not leak, 100% does not leak. Unique fluid matching design, 1PASS monochrome printing constantly ink, long time to stop working again without cleaning. Of course, the conditions are equipped with locor series of ink or other high quality compatible ink.locor series nozzle refused to inferior ink. Locor nozzle with a high quality ink needle to ensure that a successful ink, without ink, replace the nozzle can ensure that both hands clean, vacuum anti-static packaging during storage and transportation to ensure the safety of the circuit intact

Applicable to PRO series, 600 series, 700 series! Domestic pictorial machine !, ENCAD NovaJet series photo machine 600e, 600,505,500,700,750,850! Music color series photo machine 750,4000! Applicable to domestic four-color pictorial machine

New ink head method of test :

1. Install the ink head that will need to be tested (do not add ink to the inside of the ink head) in a position other than black. (Also make sure that the black ink head itself is going out and does not affect the other ink head)

2. Install the paper and start cleaning.

3. After the machine is sprayed with the first black test strip (that is, the first row of the test strip), press the pause key.

4. Remove the ink head that needs to be tested (the purpose of the removal is to prevent damage to the ink head caused by air burning).

5. Press the pause button to finish the test strip.

6. Look at the last row on the C, M, Y, K test results, if the test ink head position shows the number of pass 3, 4, 6,       8, 10, it shows that the test ink head is good.

Note :

1. Use it immediately after open the package

2. Use suited ink pins only to avoid sealing failure

3. Tighten ink pin properly when sealing,no over wind

4. Clean nozzles with distilled water only

5. LECAI ink recommended ,no inferior ink

6. Ink filled in cartridge shall be between 20-25ml

7. Too much ink filled may lead ink leakage,cartridge contacts pollution or cartridge damage

7. Blue tapes can be taken apart only when installing cartridge

9. Keep cartridge contacts and nozzles from hands to avoid being dirty or damaged